Flap Disc Adhesive Glue

We supply full range of abrasive tools, such as Flap Disc adhesive, Flap Disc Backing Pad, Abrasive Flap Disc, Flap Wheels, Flap Wheel with shaft, Abrasive Sanding Disc, Abrasive Machine, etc...

both one component epoxy adhesive and two component epoxy adhesive.

Specifications for single component epoxy adhesive for flap disc:

Appearance: Colloidal

Color: Blue / White

Odour: Slight odour

Proportion(water=1):1.42

Viscosity (25℃, mpa.s): 15000~20000

Storage time: 5℃ 6 months

Recommended curing condition: 110~130℃×4~3 hours or 150~160℃×1 hour

Hardness(Shore D): ≥90

Recommended temperture on the machine: 40-52 degree

Shearing strength(23℃, steel/steel, MPa): ≥22

Flap Wheel Glue Instructions

According to the ambient temperature, preheat adhesive among 41 ~ 46℃ before pumping into the pumping system.

Note:

1.When climate is colder, adjust preheating temperature 3 ~ 5℃ higher than normal.

2.Before use large quantities,a small quantity should be used for test.

3.This flap disc glue is a chemical product, can cause weak corrosive to skin, please note that the use of the appropriate protection, such as inadvertent contact with the skin with plenty of water rinse or alcohol wash.

4.Baking temperature is particularly important for product quality. The data provided by us is tested under accurate oven temperature control. We are strongly advised customer should adjust oven temperature according to the customer's on site condition.

Storage and transportation

Flap Disc Adhesive resin glue should keep in cool, ventilated warehouse, temperature does not exceed 40℃, relative humidity of not more than 85% ,this product is not special goods, according to the general cargo transport.